Nortel Networks 2300 Series manual Set ap radio load-balancing group

AP Commands 279

Syntax set ap ap-numradio {1 2} load-balancing {enable disable}

ap ap-number	Index value that identifies the AP on the WSS.
radio 1	Radio 1 of the AP.
radio 2	Radio 2 of the AP. (This option does not apply to single-radio models.)
enable	Enables RF load balancing for the AP radio.
disable	Disables RF load balancing for the AP radio.

Defaults RF load balancing is enabled by default for all AP radios. Access Enabled.

History Introduced in WSS Software Version 6.0.

Usage By default, RF load balancing is enabled on all AP radios. Use this command to disable or re-enable RF load balancing for the specified AP radio.

RF load balancing can also be disabled or re-enabled globally with the set load-balancing mode command. If RF load balancing has been enabled or disabled for a specific AP radio, then the setting for the individual radio takes precedence over the global setting.

Examples The following command disables RF load balancing for AP radio 1 on AP 7:

WSS# set ap 7 radio 1 load-balancing disable

success: change accepted.

See Also

•set load-balancing strictness on page 277

•clear ap radio load-balancing group on page 241

•set ap local-switching mode on page 260

•show load-balancing group on page 375

set ap radio load-balancing group

Assigns an AP radio to a load balancing group.

Syntax set ap ap-numradio {1 2} load-balancing group name [rebalance]

ap ap-number	Index value that identifies the AP on the WSS.
radio 1	Radio 1 of the AP.
radio 2	Radio 2 of the AP. (This option does not apply to single-radio models.)

Nortel WLAN—Security Switch 2300 Series Command Line Reference