Nortel Networks 2300 Series manual Set ap, See Also set port on

Port Commands 43

See Also set port on page 35

set ap

Configures a AP for an AP that is indirectly connected to the WSS through an intermediate Layer 2 or Layer 3 network.

Note. Before configuring an AP, you must use the set system countrycode command to set the IEEE 802.11 country-specific regulations on the WSS. See set system countrycode

on page 63.

Note. For a complete listing of the models in the WLAN Series 2332 and their respective countries of operation, please visit the Nortel Support website. http://www.nortel.com/support. The Series 2332 access point has been region-locked to meet geographic regulatory restrictions. Each model is associated to a specific regulatory domain and subsequent country of operation. During installation, the access point model and wireless security switch regulatory domain must match or the access point will not operate.

Note. For an AP that is directly connected to the WSS, use the set port type ap command to configure an AP access port.

Note. The WLAN Series 2332 Access Points consist of the following models:

2332-A1, 2332-A2, 2332-A3, 2332-A4, 2332-A5, 2332-A6, 2332-E1, 2332-E2, 2332-E3, 2332-E4, 2332-E5, 2332-E6, 2332-E7, 2332-E8, 2332-E9, and 2332-J1.

Syntax set ap ap-numserial-id serial-ID

model {2330 2330A 2330B 2332-A1 2332-A2 2332-A3 2332-A4 2332-A5 2332-A6 2332-E1 2332-E2 2332-E3 2332-E4 2332-E5 2332-E6 2332-E7 2332-E8 2332-E9 2332-J1 }

[radiotype {11a 11b11g}]

Nortel WLAN—Security Switch 2300 Series Command Line Reference