Nortel Networks 2300 Series Set service-profile dhcp-restrict, WSS# set service-profile sp1 cos

326AP Commands

Syntax set service-profile name cos level

name	Service profile name.
level	CoS value assigned by the AP to all traffic in the service profile.

Defaults The default static CoS level is 0. Access Enabled.

History Introduced in WSS Software Version 4.1.

Usage This command applies only when static CoS is enabled. If static CoS is disabled, prioritization is based on the QoS mode configured in the radio profile, and on any ACLs that set CoS. (See the “Configuring Quality of Service” chapter of the Nortel WLAN Security Switch 2300 Series Configuration Guide.) To enable static CoS, use the set service-profilestatic-coscommand.

Examples The following command changes the static CoS level to 7 (voice priority):

WSS# set service-profile sp1 cos 7

success: change accepted.

See Also

•set service-profilestatic-cos on page 332

•show service-profile on page 380

set service-profile dhcp-restrict

Enables or disables DHCP Restrict on a service profile. DHCP Restrict filters a newly associated client’s traffic to allow DHCP traffic only, until the client has been authenticated and authorized. All other traffic is captured by the WSS and is not forwarded. After the client is successfully authorized, the traffic restriction is removed.

Syntax set service-profile name dhcp-restrict {enable disable}

name	Service profile name.
enable	Enables DHCP Restrict.
disable	Disables DHCP Restrict.

Defaults DHCP Restrict is disabled by default. Access Enabled.

History Introduced in WSS Software Version 4.1.

Usage To further reduce the overhead of DHCP traffic, use the set service-profileno-broadcastcommand to disable DHCP broadcast traffic from AP radios to clients on the service profile’s SSID.

Examples The following command enables DHCP Restrict on service profile sp1:

WSS# set service-profile sp1 dhcp-restrict enable

success: change accepted.

NN47250-100 (Version 02.51)