Nortel Networks 2300 Series manual Help, WSS# clear system location, None, All

66System Services Commands

Examples To clear the location of the WSS, type the following command:

WSS# clear system location

success: change accepted.

See Also

•set system contact on page 62

•set system countrycode on page 63

•set system idle-timeout on page 64

•set system ip-address on page 65

•set system location on page 65

•show config on page 553

•show system on page 68

help

Displays a list of commands that can be used to configure and monitor the WSS.

Syntax	help
Defaults	None.
Access	All.

Examples Use this command to see a list of available commands. If you have restricted access, you see fewer commands than if you have enabled access. To display a list of CLI commands available at the enabled access level, type the following command at the enabled access level:

WSS# help

Commands:

-------------------------------------------------------------------------

clear	Clear, use 'clear help' for more information
commit	Commit the content of the ACL table
copy	Copy from filename (or url) to filename (or url)
crypto	Crypto, use 'crypto help' for more information
delete	Delete url
dir	Show list of files on flash device
disable	Disable privileged mode
exit	Exit from the Admin session
help	Show this help screen
history	Show contents of history substitution buffer
hit-sample-rate	Set NP hit-counter sample rate
load	Load, use 'load help' for more information
logout	Exit from the Admin session
monitor	Monitor, use 'monitor help' for more information
ping	Send echo packets to hosts
quit	Exit from the Admin session
reset	Reset, use 'reset help' for more information
rollback	Remove changes to the edited ACL table
save	Save the running configuration to persistent storage
set	Set, use 'set help' for more information
show	Show, use 'show help' for more information
telnet	telnet IP address [server port]

NN47250-100 (Version 02.51)