Nortel Networks 2300 Series manual FieldDescription

396AP Commands

Table 24: Output for show service-profile (continued)

FieldDescription

11a / 11b / 11g transmit rate fields

Data transmission rate settings for each radio type:

•beacon rate—Data rate of beacon frames sent by AP radios.

•multicast rate—Data rate of multicast frames sent by AP radios. If the rate is auto, the AP sets the multicast rate to the highest rate that can reach all clients connected to the radio.

•mandatory rates—Set of data transmission rates that clients are required to support in order to associate with an SSID on an AP radio. A client must support at least one of the mandatory rates.

•standard rates—The set of valid rates that are neither mandatory nor disabled. These rates are supported for data transmission from the AP radios.

•disabled rates—Data transmission rates that AP radios will not use to transmit data. (The radios will still accept frames from clients at disabled data rates.)

•set service-profile attr on page 306

•set service-profileauth-dot1x on page 307

•set service-profileauth-fallthru on page 308

•set service-profileauth-psk on page 309

•set service-profile beacon on page 310

•set service-profilecac-mode on page 311

•set service-profilecac-session on page 312

•set service-profilecipher-ccmp on page 312

•set service-profilecipher-tkip on page 313

•set service-profilecipher-wep104 on page 314

•set service-profilecipher-wep40 on page 315

•set service-profile cos on page 315

•set service-profiledhcp-restrict on page 316

•set service-profileidle-client-probing on page 317

•set service-profilelong-retry-count on page 319

•set service-profileno-broadcast on page 320

•set service-profileproxy-arp on page 321

•set service-profilepsk-phrase on page 322

NN47250-100 (Version 02.51)