Nortel Networks 2300 Series manual Set ap radio min-tx-datarate, Set ap radio link-calibration

278AP Commands

set ap radio min-tx-datarate

To specify the minimum rate at which a radio is allowed to transmit traffic to clients, see Deprecated in WSS

Software Version 5.0. on page 266.

set ap radio link-calibration

Configures an AP radio to emit link calibration packets, which can aid in positioning a Mesh AP.

Syntax set ap ap-numberradio {1 2} link-calibration mode {enable disable}

ap ap-number	Index value that identifies the AP on the WSS.
radio 1	Radio 1 of the AP.
radio 2	Radio 2 of the AP. (This option does not apply to single-radio models.)
enable	Enables link calibration packets for the AP radio.
disable	Disables link calibration packets for the AP radio.

Defaults Disabled. Access Enabled.

History Introduced in WSS Software Version 6.0.

Usage A Mesh Portal AP can be configured to emit link calibration packets to assist with positioning the Mesh AP. A link calibration packet is an unencrypted 802.11 management packet of type Action. When enabled on an AP, link calibration packets are sent at a rate of 5 per second.

Only one radio on an AP can be configured to send link calibration packets. Link calibration packets are intended to be used only during installation of APs; they are not intended to be enabled on a continual basis.

Examples The following command enables link calibration packets for AP radio 1 on AP 7:

WSS# set ap 7 radio 1 link-calibration mode enable success : anchor calibration enabled on AP 7 on radio 1.

See Also

•set ap boot-configuration mesh ssid on page 254

•set service-profile mesh on page 320

•show ap mesh-links on page 357

set ap radio load-balancing

Disables or enables RF load balancing for an AP radio.

NN47250-100 (Version 02.51)