Nortel Networks 2300 Series manual Show tunnel, Output for show security l2-restrict

98VLAN Commands

Examples The following command shows Layer 2 forwarding restriction information for all VLANs:

WSS# show security l2-restrict
VLAN Name	En Drops Permit MAC	Hits

---- ---------------- -- ---------- ------------------- ---------------------

1 default	Y	0 00:0b:0e:02:53:3e	5947
		00:30:b6:3e:5c:a8	9
2 vlan-2	Y	0 04:04:04:04:04:04	0

Table 14 describes the fields in the display.

	Table 4: Output for show security l2-restrict
Field	Description
VLAN	VLAN number.
Name	VLAN name.
En	Enabled state of the feature for the VLAN:
	• Y—Enabled. Forwarding of Layer 2 traffic from clients is
	restricted to the MAC address(es) listed under Permit
	MAC.
	• N—Disabled. Layer 2 forwarding is not restricted.
Drops	Number of packets dropped because the destination MAC address was not
	one of the addresses listed under Permit MAC.
Permit MAC	MAC addresses to which clients in the VLAN are allowed to send traffic at
	Layer 2.
Hits	Number of packets whose source MAC address was a client in this VLAN,
	and whose destination MAC address was one of those listed under Permit
	MAC.

See Also

•clear security l2-restrict on page 75

•clear security l2-restrict counters on page 75

•set security l2-restrict on page 78

show tunnel

Displays the tunnels from the WSS where you type the command.

Syntax show tunnel

Defaults None.

Access Enabled

NN47250-100 (Version 02.51)