Nortel Networks 2300 Series manual Set server group load-balance, Servers in the group

RADIUS and Server Groups Commands 503

See Also

•clear server group on page 486

•set server group load-balance on page 493

•show aaa on page 210

set server group load-balance

Enables or disables load balancing among the RADIUS servers in a server group.

Syntax set server group group-nameload-balance {enable disable}

group-name	Server group name of up to 32 characters.
load-balance	Enables or disables load balancing of authentication requests among
enable disable	the servers in the group.

Defaults Load balancing is disabled by default. Access Enabled.

History Introduced in WSS Software 1.0.

Usage You can optionally enable load balancing after assigning the server group members. If you configure load balancing, WSS Software sends each AAA request to a separate server, starting with the first one on the list and skipping unresponsive servers. If no server in the group responds, WSS Software moves to the next method configured with set authentication and set accounting.

In contrast, if load balancing is not configured, WSS Software always begins with the first server in the list and sends unfulfilled requests to each subsequent server in the group before moving on to the next configured AAA method.

Examples To enable load balancing between the members of server group shorebirds, type the following command:

23x0# set server group shorebirds load-balance enable

success: change accepted.

To disable load balancing between shorebirds server group members, type the following command:

23x0# set server group shorebirds load-balance disable

success: change accepted.

See Also

•clear server group on page 486

•clear radius server on page 486

•set server group on page 492

•show aaa on page 210

Nortel WLAN—Security Switch 2300 Series Command Line Reference