Nortel Networks 2300 Series manual Set radio-profile auto-tune power-ramp-interval

AP Commands 295

set radio-profile auto-tune power-ramp-interval

Changes the interval at which power is increased or decreased, in 1 dBm increments, on radios in a radio profile until the optimum power level calculated by RF Auto-Tuning is reached.

Syntax set radio-profile name auto-tune power-ramp-interval seconds

name	Radio profile name.
seconds	Number of seconds WSS Software waits before increasing or decreasing
	radio power by another 1 dBm. You can specify from 1 to 65535.

Defaults The default interval is 60 seconds. Access Enabled.

History Introduced in WSS Software Version 5.0.

Examples The following command changes the power ramp interval for radios in radio profile rp2 to 120 seconds:

WSS# set radio-profile rp2 auto-tune power-ramp-interval 120

success: change accepted.

See Also

•set ap radio auto-tunemax-power on page 265

•set radio-profileauto-tunepower-config on page 282

•set radio-profileauto-tunepower-interval on page 283

•set radio-profileauto-tunepower-lockdown on page 284

•show radio-profile on page 376

set radio-profile beacon-interval

Changes the rate at which each AP radio in a radio profile advertises its service set identifier (SSID).

Syntax set radio-profile name beacon-interval interval

name	Radio profile name.
interval	Number of milliseconds (ms) between beacons. You can specify from
	25 ms to 8191 ms.

Defaults The beacon interval for AP radios is 100 ms by default. Access Enabled.

Usage You must disable all radios that are using a radio profile before you can change parameters in the profile. Use the set radio-profile mode command.

Nortel WLAN—Security Switch 2300 Series Command Line Reference