Nortel Networks 2300 Series manual Set ap image, WSS# set ap 1,4,7 group loadbalance1

	AP Commands 269
History
Version 4.0	Option auto added for configuration of the AP configuration
	profile.
Version 6.0	Option dap removed.

Usage You can assign any subset or all of the APs connected to a WSS to a group on that switch. All access points in a group must be connected to the same WSS.

If you use the name none, spelled in any combination of capital or lowercase letters, the specified AP is cleared from all AP groups.

Examples The following command configures an AP group named loadbalance1 that contains the APs on ports 1, 4, and 7:

WSS# set ap 1,4,7 group loadbalance1

success: change accepted.

The following command removes the AP on port 4 from all AP groups:

WSS# set ap 4 group none

success: change accepted.

See Also

•show ap config on page 344

•show ap group on page 357

set ap image

Loads an AirDefense image on an AP.

Syntax set ap ap-number image filename

ap ap-number		Index value that identifies the AP on the WSS.
filename		Name of the AirDefense sensor software image file. This file is assumed
		to have been copied to the WSS.
Defaults	None.
Access	Enabled.
History
Version 5.0		Command introduced.
Version 6.0		Option dap removed.

Usage After the AirDefense sensor software is copied to the WSS, use this command to configure an AP to load the software. When you do this, the software is transferred to the AP, which then reboots and comes up as an AirDefense sensor.

Nortel WLAN—Security Switch 2300 Series Command Line Reference