Nortel Networks 2300 Series manual Output for show ap config

356AP Commands

	Table 7: Output for show ap config
Field	Description
Port	WSS port number.
	Note: This field is applicable only if the AP is directly connected
	to the WSS and the WSS’s port is configured as an AP access
	port.
AP	Connection ID for the AP.
	Note: This field is applicable only if the AP is configured on the
	WSS as a AP.
serial-id	Serial ID of the AP.
	Note: This field is displayed only for APs.
AP model	AP model number.
POE	PoE state on the WSS port:
	•	Enable
	•	Disable
bias	Bias of the WSS connection to the AP:
	•	High
	•	Low
name	AP name.
fingerprint	Hexadecimal fingerprint of the AP’s public encryption key.
	Note: This field is displayed only for APs. If the field is blank,
	the key has not been verified yet by an administrator. (See set ap
	fingerprint on page 257.)
boot-download-enable	State of the firmware upgrade option:
	• YES (automatic upgrades are enabled)
	• NO (automatic upgrades are disabled)
force-image-download	State of the option to force the AP to o
load balancing group	Names of the AP load-balancing groups to which the AP
	belongs. If the value is None, the access point does not belong to
	any load balancing groups.
	Note: This field is displayed only if the AP is a member of a
	group.
Radio	Radio number. The information listed below this field applies
	specifically to the radio.

NN47250-100 (Version 02.51)