Nortel Networks 2300 Series manual System Services Commands

63

System Services Commands

Use system services commands to configure and monitor system information for a WLAN—Security Switch (WSS). This chapter presents system services commands alphabetically. Use the following table to located commands in this chapter based on their use.

Configuration	quickstart on page 57
Auto-Config	set auto-config on page 57
Display	clear banner motd on page 54
	set banner motd on page 59
	show banner motd on page 67
	set confirm on page 60
	set length on page 60
System Identification	set prompt on page 62
	set system name on page 66
	set system location on page 65
	set system contact on page 62
	set system countrycode on page 63
	set system idle-timeout on page 64
	set system ip-address on page 65
	show load on page 67
	show system on page 68
	clear system on page 55
	clear prompt on page 55
Help	help on page 56
History	history on page 57
	clear history on page 54
License	set license on page 61

Nortel WLAN—Security Switch 2300 Series Command Line Reference