276AP Commands

Syntax set {ap port-list

auto}} radio {1 2} auto-tune max-power power-level

ap port-list

List of ports connected to the AP on which to set the

 

maximum power.

ap ap-num

Number of a AP on which to set the maximum power.

ap auto

Sets the maximum power for radios configured by the AP

 

configuration profile. (See set ap auto on page 245.)

radio 1

Radio 1 of the AP.

radio 2

Radio 2 of the AP. (This option does not apply to single-radio

 

models.)

power-level

Maximum power setting RF Auto-Tuning can assign to the

 

radio, expressed as the number of decibels in relation to 1

 

milliwatt (dBm). You can specify a value from 1 up to the

 

maximum value allowed for the country of operation.

 

The power-levelcan be a value from 1 to 20.

Defaults The default maximum power setting that RF Auto-Tuning can set on a radio is the highest setting allowed for the country of operation or highest setting supported on the hardware, whichever is lower.

Access Enabled.

History

Version 4.0

Option auto added for configuration of the AP configuration

 

profile.

Version 6.0

Option dap removed.

Examples The following command sets the maximum power that RF Auto-Tuning can set on radio 1 on the AP on port 7 to 12 dBm.

WSS# set ap 7 radio 1 auto-tune max-power 12

success: change accepted.

See Also

set radio-profileauto-tunepower-config on page 282

set radio-profileauto-tunepower-interval on page 283

set ap radio auto-tune max-retransmissions

Deprecated in WSS Software Version 5.0.

set ap radio auto-tune min-client-rate

Deprecated in WSS Software Version 5.0. To configure radio transmit rates, See set service-profiletransmit-rates on

page 334.

NN47250-100 (Version 02.51)

Page 276
Image 276
Nortel Networks 2300 Series manual Set ap radio auto-tune max-retransmissions, Set ap radio auto-tune min-client-rate