Nortel Networks 2300 Series manual Set service-profile tkip-mc-time

Models: 2300 Series

1 622
Download 622 pages 48.74 Kb
Page 343
Image 343

AP Commands 343

any ACLs that mark CoS. This option provides a simple way to configure an SSID for priority traffic such as VoIP traffic.

When static CoS is enabled, the standard WSS Software prioritization mechanism is not used. Instead, the AP sets CoS as follows:

For traffic from the AP to clients, the AP places the traffic into the forwarding queue that corresponds to the CoS level configured on the service profile. For example, if the static CoS level is set to 7, the AP radio places client traffic in its Voice queue.

For traffic from clients to the network, the AP marks the DSCP value in the IP headers of the tunnel packets used to carry the user data from the AP to the WSS.

Syntax set service-profile name static-cos {enable disable}

name

Service profile name.

enable

Enables static CoS on the service profile.

disable

Disables static CoS on the service profile.

Defaults Static CoS is disabled by default.

Access Enabled.

History Introduced in WSS Software Version 4.1.

Usage The CoS level is specified by the set service-profile cos command.

Examples The following command enables static CoS on service profile sp1:

WSS# set service-profile sp1 static-cos enable

success: change accepted.

See Also

set service-profile cos on page 315

show service-profile on page 380

set service-profile tkip-mc-time

Changes the length of time that AP radios use countermeasures if two message integrity code (MIC) failures occur within 60 seconds. When countermeasures are in effect, AP radios dissociate all TKIP and WPA WEP clients and refuse all association and reassociation requests until the countermeasures end.

Syntax set service-profile name tkip-mc-time wait-time

name

Service profile name.

wait-time

Number of milliseconds (ms) countermeasures remain in effect. You can

 

specify from 0 to 60,000.

Defaults The default countermeasures wait time is 60,000 ms (60 seconds).

Access

Enabled.

Nortel WLAN—Security Switch 2300 Series Command Line Reference

Page 343
Image 343
Nortel Networks 2300 Series Set service-profile tkip-mc-time, Syntax set service-profile name static-cos enable disable