Nortel Networks 2300 Series manual Set ap boot-configuration mesh ssid

264AP Commands

Examples The following command configures AP7 to use a raw PSK to authenticate with a Mesh Portal AP:

WSS# set ap 7 boot-configuration mesh psk-raw

c25d3fe4483e867d1df96eaacdf8b02451fa0836162e758100f5f6b87965e59d

success: change accepted.

See Also

•set ap boot-configuration mesh ssid on page 254

•set service-profile mesh on page 320

•show ap mesh-links on page 357

set ap boot-configuration mesh ssid

Specifies the name of the SSID a Mesh AP attempts to associate with when it is booted.

Syntax set ap ap-numberboot-configuration mesh ssid mesh-ssid

ap ap-number		Index value that identifies the AP on the WSS.
mesh-ssid		Name of the mesh SSID (up to 32 characters).
Defaults	None.
Access	Enabled.

History Introduced in WSS Version 6.0.

Usage You must connect the AP to an WSS and enter this command to specify the mesh SSID prior to deploying the Mesh AP in its final untethered location. When the AP is booted its untethered location, and it determines that it has no Ethernet link to the network, it then associates with the specified mesh-ssid.

Note. When the mesh-ssidis specified, the regulatory domain of the WSS and the power restrictions are copied to the AP flash memory. This prevents the Mesh AP from operating outside of regulatory limits after it is booted and before it receives its complete configuration from the WSS switch. Consequently, it is important that the regulatory and antenna information specified on the WSS switch actually reflects the locale where the Mesh AP is to be deployed, in order to avoid regulatory violations.

Examples The following command configures AP 7 to attempt to associate with the SSID WLAN-mesh when booted in an untethered location:

WSS# set ap 7 boot-configuration mesh ssid wlan-mesh

success: change accepted.

NN47250-100 (Version 02.51)