Nortel Networks 2300 Series manual Boot boot FN=WSS010101.020 DEV=boot1, Change on Show on

598Boot Prompt Commands

Usage If you use an optional parameter, the parameter setting overrides the setting of the same parameter in the currently active boot profile. However, the boot profile itself is not changed. To display the currently active boot profile, use the show command. To change the currently active boot profile, use the change command.

Examples The following command loads system image file WSS010101.020 from boot partition 1:

boot> boot FN=WSS010101.020 DEV=boot1

Compact Flash load from boot1:testcfg matches WSS010101.020. unzip: Inflating ramdisk_1.1.1.. OK

unzip file len 36085486 OK

Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003

The NetBSD Foundation, Inc. All rights reserved.

Copyright (c) 1982, 1986, 1989, 1991, 1993

The Regents of the University of California. All rights reserved.

Power Cycle Reboot Detecting hardware...done.

readclock: 2003-10-8 2:9:50.67 UTC=>1065578990.670000 (1064992894)

init: Creating mfs /dev

erase ^H, werase ^W, kill ^U, intr ^C, status ^T Doing Nortel mounts and links

Starting nos_mon...

nos_mon:ps: not found

SYSLOGD Oct 08 02:10:05.477814 CRITICAL SYSTEM_READY: The system has finished booting.

Copyright (c) 2002, 2003

Nortel, Inc.

Username:

Password:

See Also

•change on page 588

•show on page 596

change

Changes parameters in the currently active boot profile. (For information about boot profiles, see show on page 596.)

Syntax change

Defaults The default boot type is c (compact flash). The default filename is default. The default flags setting is 0x00000000 (all flags disabled) and the default options list is run=nos;boot=0. The default device setting is the boot partition specified by the most recent set boot partition command typed at the Enabled level of the CLI, or boot 0 if the command has never been typed.

NN47250-100 (Version 02.51)