Nortel Networks 2300 Series Hit-sample-rate, Rollback security acl, See Also show security acl on

Security ACL Commands 463

See Also

•clear security acl on page 449

•rollback security acl on page 453

•set security acl on page 454

•show security acl on page 461

•show security acl info on page 463

hit-sample-rate

This command has been renamed in WSS Software Version 4.1. To configure the hit sample rate, see set security acl

hit-sample-rate on page 460.

rollback security acl

Clears changes made to the security ACL edit buffer since it was last saved. The ACL is rolled back to its state after the last commit security acl command was entered. All uncommitted ACLs in the edit buffer are cleared.

Syntax rollback security acl {acl-nameall}

acl-name	Name of an existing security ACL to roll back. ACL names must start
	with a letter and are case-insensitive.
all	Rolls back all security ACLs in the edit buffer, clearing all uncommitted
	ACEs.
Defaults	None.
Access	Enabled.

Examples The following commands show the edit buffer before a rollback, clear any changes in the edit buffer to security acl_122, and show the edit buffer after the rollback:

WSS# show security acl info all editbuffer

ACL edit-buffer information for all

set security acl ip acl_122 (ACEs 3, add 3, del 0, modified 0)

---------------------------------------------------------

1.permit IP source IP 20.0.1.11 0.0.0.255 destination IP any enable-hits

2.deny IP source IP 20.0.2.11 0.0.0.0 destination IP any

3.deny SRC source IP 192.168.1.234 255.255.255.255 enable-hits

WSS# rollback security acl acl_122

WSS# show security acl info all editbuffer

ACL edit-buffer information for all

See Also show security acl on page 461

Nortel WLAN—Security Switch 2300 Series Command Line Reference