Nortel Networks 2300 Series manual 11g-only, Rfid-mode, Wmm-powersave

			AP Commands 303
History
Version 4.1	•	Parameters that no longer apply to radio profiles
		in WSS Software Version 4.1 removed:
		•	11g-only
		•	long-retry
		•	short-retry
	• wmm parameter name changed to qos-mode.
Version 5.0	Parameters added:
	•	rfid-mode
	•	wmm-powersave

Usage Use the command without any optional parameters to create new profile. If the radio profile does not already exist, WSS Software creates a new radio profile. Use the enable or disable option to enable or disable all the radios using a profile. To assign the profile to one or more radios, use the set ap radio radio-profilecommand.

To change a parameter in a radio profile, you must first disable all the radios in the profile. After you complete the change, you can reenable the radios.

To enable or disable specific radios without disabling all of them, use the set ap radio command. Examples The following command configures a new radio profile named rp1:

WSS# set radio-profile rp1

success: change accepted.

The following command enables the radios that use radio profile rp1:

WSS# set radio-profile rp1 mode enable

The following commands disable the radios that use radio profile rp1, change the beacon interval, then reenable the radios:

WSS# set radio-profile rp1 mode disable

WSS# set radio-profile rp1 beacon-interval 200

WSS# set radio-profile rp1 mode enable

The following command enables the WPA IE on AP radios in radio profile rp2:

WSS# set radio-profile rp2 wpa-ie enable

success: change accepted.

See Also

•set ap radio mode on page 270

•set ap radio radio-profile on page 271

•show ap config on page 344

•show radio-profile on page 376

Nortel WLAN—Security Switch 2300 Series Command Line Reference