Nortel Networks 2300 Series manual Output for show ap counters

AP Commands 359

TKIP Pkt Replays			0	TKIP Decrypt Err		0
CCMP Pkt Decrypt Err			0	CCMP Pkt Replays 0
CCMP Pkt Transfer Ct			0	RadioResets		0
Radio Recv Phy Err Ct			0	Transmit Retries		60501
Radio Adjusted Tx Pwr			15	Noise Floor		-93
802.3 Packet Tx Ct			0	802.3 Packet Rx Ct 0
No Receive Descriptor			0
TxUniPkt TxUniByte RxPkt UndcrptPkt TxMultiPkt TxMultiByte RxByte UndcrptByte PhyErr
1.0:1017	0	10170		0	14	8347	0	0	3964
2.0:5643	55683	822545		8697520	3	1670	0	0	8695
5.5:0	0	0		0	5	258	0	0	4
6.0:	0	0		0	0	0	0	0	51
9.0: 0	0	0		0	1	172	0	0	53
11.0: 0	0	0		0	17	998	0	0	35
12.0: 0	0	0		0	0	0	0	0	26
18.0: 0	0	0		0	0	0	0	0	38
24.0: 0	0	0		0	0	0	0	0	47
36.0: 0	0	0		0	0	0	0	0	1
48.0: 0	0	0		0	1	68	0	0	29
54.0: 0	0	0		0	0	0	0	0	5
TOTL: 6660 55683 832715				8697520		41 11513	0	0	0 12948
...

Table 41 describes the fields in this display.

	Table 8: Output for show ap counters
Field	Description
AP	AP number.
Port	WSS port number (if the AP is directly connected to the WSS
	and the WSS port is configured as an AP access port).
radio	Radio number.
LastPktXferRate	Data transmit rate, in Mbps, of the last packet received by the
	AP.
NumCntInPwrSave	Number of clients currently in power save mode.
LastPktRxSigStrength	Signal strength, in dBm, of the last packet received by the AP.
LastPktSigNoiseRatio	Signal-to-noise ratio (SNR), in decibels (dB), of the last packet
	received by the AP.
	This value indicates the strength of the radio signal above the
	noise floor. For example, if the noise floor is -88 and the signal
	strength is -68, the SNR is 20.
	If the value is below 10, this indicates a weak signal and might
	indicate a problem in the RF environment.
TKIP Pkt Transfer Ct	Total number of TKIP packets sent and received by the radio.

Nortel WLAN—Security Switch 2300 Series Command Line Reference