Nortel Networks 2300 Series manual Clear radio-profile

252AP Commands

Examples The following command clears radio 1 on AP 7 from the load balancing group to which it had been assigned:

WSS# clear ap 7 radio 1 load-balancing group

success : change accepted.

See Also

•set load-balancing strictness on page 277

•set ap radio load-balancing on page 268

•set ap local-switching mode on page 260

•show load-balancing group on page 375

clear radio-profile

Removes a radio profile or resets one of the profile’s parameters to its default value.

Syntax clear radio-profile name [parameter]

name	Radio profile name.
parameter	Radio profile parameter:
	•	beacon-interval
	•	countermeasures
	•	dtim-interval
	•	frag-threshold
	•	max-rx-lifetime
	•	max-tx-lifetime
	•	preamble-length
	•	rts-threshold
	•	service-profile

(For information about these parameters, see the set radio-profilecommands that use them.)

Defaults If you reset an individual parameter, the parameter is returned to the default value listed in Table 37 on page 291.

Access Enabled.

NN47250-100 (Version 02.51)