Nortel Networks 2300 Series manual Set qos dscp-to-cos-map, Show qos

Quality of Service Commands 105

set qos dscp-to-cos-map

Changes the internal QoS value to which WSS Software maps a packet’s DSCP value when classifying inbound packets.

Syntax set qos dscp-to-cos-map dscp-rangecos level

dscp-range	DSCP range. You can specify the values as decimal numbers. Valid
	decimal values are 0 to 63.
	To specify a range, use the following format: 40-56. Specify the
	lower number first.
cos level	Internal QoS value. You can specify a number from 0 to 7.

Defaults The defaults are listed by the show qos command.

Access Enabled.

History Introduced in WSS Software Version 4.1.

Examples The following command maps DSCP values 40-56 to internal CoS value 6:

WSS# set qos dscp-to-cos-map 40-56 cos 6

warning: cos 5 is marked with dscp 63 which will be classified as cos 7

warning: cos 7 is marked with dscp 56 which will be classified as cos 6

As shown in this example, if the change results in a change to CoS, WSS Software displays a warning message indi- cating the change.

See Also

•set qos cos-to-dscp-map on page 94

•show qos on page 95

show qos

Displays the switch’s QoS settings.

Syntax show qos [default]

default Displays the default mappings.

Defaults None.

Access Enabled.

History Introduced in WSS Software Version 4.1.

Examples The following command displays the default QoS settings:

WSS# show qos default

Nortel WLAN—Security Switch 2300 Series Command Line Reference