Nortel Networks 2300 Series manual Radius and Server Groups Commands, Clear radius

493

RADIUS and Server Groups

Commands

Use RADIUS commands to set up communication between a WSS and groups of up to four RADIUS servers for remote authentication, authorization, and accounting (AAA) of administrators and network users. This chapter presents RADIUS commands alphabetically. Use the following table to locate commands in this chapter based on their uses.

RADIUS Client	set radius client system-ip on page 488
	clear radius client system-ip on page 484
RADIUS Servers	set radius on page 487
	set radius server on page 490
	clear radius on page 483
	clear radius server on page 486
Server Groups	set server group on page 492
	set server group load-balance on page 493
	clear server group on page 486
RADIUS Proxy	set radius proxy client on page 489
	set radius proxy port on page 489
	clear radius proxy client on page 485
	clear radius proxy port on page 485

(For information about RADIUS attributes, see the RADIUS appendix in the Nortel WLAN 2300 System Software Configuration Guide.)

clear radius

Resets parameters that were globally configured for RADIUS servers to their default values.

Syntax clear radius {deadtime key retransmit timeout}

deadtime	Number of minutes to wait after declaring an unresponsive RADIUS
	server unavailable before retrying the RADIUS server.
key	Password (shared secret key) used to authenticate to the RADIUS server.

Nortel WLAN—Security Switch 2300 Series Command Line Reference