Kramer Electronics RC-SV manual Port Mapping, IR Command Area Window

The RC Configuration Software

Figure 13: IR Command Area Window

You can test the IR command by connecting the RC unit IR terminal block connectors to the device via the IR emitter, and then clicking the IR-Out Testing button.

Figure 14 shows how to connect the IR emitter1. The white striped side connects to IR OUT, the black side connects to the Ground, and the LED Emitter Shell is affixed to the IR sensor window with the adhesive layer.

Figure 14: IR Emitter Wiring

NOTE: The dual IR emitter emits a weaker IR signal that may not be detected

by some devices

4.3 Port Mapping

The Port Manager window defines the ports on the Master device (SV-551or RC-6x,depending on the type of installation) and lets you write a description and assign a default driver for each port. For example, if a DVD is connected to the SV-551via the IR_2 port, you can change the description next to that port to “Sony DVD” and assign the Sony DVD driver to this port.

In this way, the Sony driver will be associated with the Sony DVD port2 when creating a command sequence as illustrated in Figure 15, making it easier to

1 Using the Kramer 3.5mm to IR Emitter Control Cable (C-A35/IRE-10) 2 Although you can assign it with a different Vendor or Device

13