Kramer Electronics RC-SV Creating a Driver Command, An RS-232 Command - Switch Input to Output

Creating a Macro

5.2 Creating a Driver Command

The driver commands for each port are slightly different. The following sections describe how to write a new command for the different ports.

5.2.1An RS-232 Command – Switch Input to Output

To add a driver command to a button (for example, to switch the DVD player to the projector), do the following:

1.Open the Port drop-down box and select the RS-232 Terminal Block (or IR OUT or RS-485) port1 from the list2.

If a driver was assigned in the port mapping stage, the default driver associated with this port appears.

2.In the RC command area, write the command description (for example, SWITCH).

3.Select the Driver command (for example, ª COMP!º ) from the drop-down box2.

Figure 32 illustrates the RS-232 RC Command area as it appears after writing the driver command:

Figure 32: Switch to COMP1 Command

1 Once the port is selected, the default driver details appear

2 If the required data does not exist, you can install it via the Manager Driver window (see section 4￿ .1)

23