Creating a Macro
Figure 34: Switcher RC Command
5.2.4A Power Amplifier Command
To write a power amplifier command1 on an RC button, do the following:
1.Select the POWER_AMP Port.
2.In the RC command area, write the command description (for example, High Volume).
3.Select the power amplifier command (for example, Volume set).
4.Move the sliding switch to the desired volume (for example, 12dB).
Figure 34 illustrates the RC Command area as it appears after writing the command:
Figure 35: High Volume RC Command
1 For the
25
