Kramer Electronics RC-SV manual Kramer RC Configuration Window Features, Device Area

				The RC Configuration Software
			Table 3: Kramer RC Configuration Window Features
#			Feature			Function
1		Menu Bar			Menus are described in section 6￿
	Device Area
2		Name Box			Displays the name of the specific device1
3		Connection Box			Displays the connection properties with the device (IP address or
					com port)1
4		Master Box			Select the Master device to which the slave keypad is connected.
					Click the change button to change the master device type and
					the Slave Keypad appearance (from a list)
5		Keypad Box			Select the device type2
6		Slave Keypad Tab			Shows the layout of the RC buttons according to the device type
					selected, with the labels on the button. Click to Select a button to
					configure, modify, read, or delete its macro.
					When the button is:
					￿ Blue rimmed, it is assigned a command sequence
					￿ Green, it is selected
					￿ Gray, it is not assigned a macro
7		Event Macros Tab			By default, one event command sequence is assigned and can
					have commands added to it: Startup – a series of commands to be
					executed upon unit startup (see Figure 18)
8		Button Area3		Label Text Box	Select a button and type the required button label
9				Behavior Drop-	Assign the button response to press and release actions
				down Box
					Button Definition	Behavior
					Activate on Release	The macro is executed upon releasing
					(default)	the button
					Activate while Pressed	The macro is activated and repeated
						for as long as the button is pressed
					Toggle 1-2-3-4	Cycling macro behavior:
						The button can be assigned with up to
						4 different macros. Each time it is
						pressed, the next macro in the set will
						be activated in a cyclic fashion.4
					Toggle Press-Release	Dual macro behavior:
						One macro is activated when pressing
						the button and the other is activated
						when releasing the button
					Disabled	The button is disabled
10		Write Configuration		Button5	Press to write the configuration of all the buttons to the device

1 The name and IP number are initially set by the Properties dialog box (see section 7￿ .2)

2 The device type can be selected only if there is no device connected to the computer. If a device is connected, the device type is selected automatically

3 The Button area appears only after selecting a button in the Front Panel tab

4 The number of toggle states can be determined (from 1 to 4). The selected number of toggle states appears above the Button Macro area (see Figure 19)

5 This button is enabled only when a device is connected to the PC. Otherwise it is disabled

16 KRAMER: SIMPLE CREATIVE TECHNOLOGY