Nortel Networks 2300 Series manual Show igmp statistics, Output for show igmp receiver-table

	IGMP Snooping Commands 441
	Table 4: Output for show igmp receiver-table
Field	Description
VLAN	VLAN that contains the multicast receiver ports. Ports are listed
	separately for each VLAN.
Session	IP address of the multicast group being received.
Port	Physical port through which the WSS can reach the receiver.
Receiver-IP	IP address of the receiver.
Receiver-MAC	MAC address of the receiver.
TTL	Number of seconds before this entry ages out if the WSS does
	not receive a group membership message from the receiver. For
	static multicast receiver entries, the TTL value is undef. Static
	multicast receiver entries do not age out.

See Also set igmp receiver on page 422

show igmp statistics

Displays IGMP statistics.

Syntax show igmp statistics [vlan vlan-id]

vlan vlan-id	VLAN name or number. If you do not specify a VLAN, WSS Software
	displays IGMP statistics for all VLANs.

Defaults None.

Access All.

Examples The following command displays IGMP statistics for VLAN orange:

WSS# show igmp statistics vlan orange

IGMP statistics for vlan orange:

IGMP message type Received Transmitted Dropped

----------------- -------- ----------- -------

General-Queries	0	0	0
GS-Queries	0	0	0
Report V1	0	0	0
Report V2	5	1	4
Leave	0	0	0
Mrouter-Adv	0	0	0
Mrouter-Term	0	0	0
Mrouter-Sol	50	101	0

Nortel WLAN—Security Switch 2300 Series Command Line Reference