Nortel Networks 2300 Series Telnet, Syntax telnet ip-addr hostname port port-num, WSS# telnet

172IP Services Commands

telnet

Opens a Telnet client session with a remote device.

Syntax telnet {ip-addr hostname} [port port-num]

ip-addr	IP address of the remote device.
hostname	Hostname of the remote device.
port port-num	TCP port number on which the TCP server on the remote device listens
	for Telnet connections.

Defaults WSS Software attempts to establish Telnet connections with TCP port 23 by default. Access Enabled.

Usage To end a Telnet session from the remote device, press Ctrl+t or type exit in the management session on the remote device. To end a client session from the local device, use the clear sessions telnet client command.

If the configuration of the WSS from which you enter the telnet command has an ACL that denies Telnet client traffic, the ACL also denies access by the telnet command.

Examples In the following example, an administrator establishes a Telnet session with another WSS and enters a command on the remote switch:

WSS# telnet 10.10.10.90

Session 0 pty tty2.d Trying 10.10.10.90...

Connected to 10.10.10.90

Disconnect character is '^t'

Copyright (c) 2002, 2003

Nortel, Inc.

Username: username

Password: password

WSS-remote> show vlan
Admin	VLAN	Tunl	Port
VLAN Name Status	State	Affin Port Tag	State

---- ---------------- ------ ----- ----- ---------------- ----- ----------------

1 default	Up	Up	5
			1	none	Up
3 red	Up	Up	5
10 backbone	Up	Up	5
			21	none	Up
			22	none	Up

NN47250-100 (Version 02.51)