Nortel Networks 2300 Series manual Set spantree portfast, Snmp Port Path Cost Defaults

406STP Commands

Defaults The default port cost depends on the port speed and link type. Table 58 lists the defaults for STP port path cost.

Table 1.SNMP Port Path Cost Defaults

Port Speed	Link Type	Default Port Path
		Cost
1000 Mbps	Full Duplex Aggregate Link (Port	19
	Group)
1000 Mbps	Full Duplex	4
100 Mbps	Full Duplex Aggregate Link (Port	19
	Group)
100 Mbps	Full Duplex	18
100 Mbps	Half Duplex	19
10 Mbps	Full Duplex Aggregate Link (Port	19
	Group)
10 Mbps	Full Duplex	95
10 Mbps	Half Duplex	100

Access Enabled.

Usage This command applies only to the default VLAN (VLAN 1). To change the cost of a port in another VLAN, use the set spantree portvlancost command.

Examples The following command changes the cost on ports 3 and 4 to 20:

WSS# set spantree portcost 3,4 cost 20

success: change accepted.

See Also

•clear spantree portcost on page 390

•clear spantree portvlancost on page 391

•set spantree portvlancost on page 397

•show spantree on page 400

•show spantree portvlancost on page 406

set spantree portfast

Enables or disables STP port fast convergence on one or more ports on a WSS.

Syntax set spantree portfast port port-list{enable disable}

port port-list List of ports. WSS Software enables the feature on the specified ports.

NN47250-100 (Version 02.51)