Nortel Networks 2300 Series Md5, WSS# load config testconfig1, Syntax md5 boot0 boot1filename

554File Management Commands

Defaults The default file location is nonvolatile storage.

Note. The current version supports loading a configuration file only from the switch’s nonvolatile storage. You cannot load a configuration file directly from a TFTP server.

If you do not specify a filename, WSS Software uses the same configuration filename that was used for the previous configuration load. For example, if the WSS used configuration for the most recent configuration load, WSS Software uses configuration again unless you specify a different filename. To display the filename of the configuration file WSS Software loaded during the last reboot, use the show boot command.

Access Enabled.

Usage This command completely replaces the running configuration with the configuration in the file.

Examples The following command reloads the configuration from the most recently loaded configuration file:

WSS# load config

Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n) [n]y success: Configuration reloaded

The following command loads configuration file testconfig1:

WSS# load config testconfig1

Reloading configuration may result in lost of connectivity, do you wish to continue? (y/n) [n]y success: Configuration reloaded

See Also

•save config on page 548

•show boot on page 551

•show config on page 553

md5

Calculates the MD5 checksum for a file in the switch’s nonvolatile storage.

Syntax md5 [boot0: boot1:]filename

boot0: boot1: Boot partition into which you copied the file.

filename Name of the file.

Defaults None.

Access Enabled.

History Introduced in WSS Software Version 4.0.

Usage You must include the boot partition name in front of the filename. If you specify only the filename, the CLI displays a message stating that the file does not exist.

NN47250-100 (Version 02.51)