Nortel Networks 2300 Series AP Commands, Set ap radio mode on, Set ap radio radio-profile on

243

AP Commands

Use AP commands to configure and manage APs. Be sure to do the following before using the commands:

•Define the country-specific IEEE 802.11 regulations on the WSS. (See set system countrycode on page 63.)

•Install the AP and connect it to a port on the WSS. (See the Nortel Access Point 2330/2330A/2330B Installation Guide or Nortel Series 2332 Access Point Installation Guide.)

•Configure an AP access port (for a directly connected AP) or a AP. (See set port type ap on page 41 and set ap on page 33.)

Caution! Changing the system country code after AP configuration disables APs and deletes their configuration. If you change the country code on a WSS, you must reconfigure all APs.

Note. For Series 2332 access points, be sure the system country code is supported for the selected access point model.

This chapter presents AP commands alphabetically. Use the following table to locate commands in this chapter based on their use.

Automatic Configuration of	set ap auto on page 245
APs	set ap auto mode on page 247
	set ap auto radiotype on page 248
	set ap auto persistent on page 247
	set ap bias on page 249
	set ap blink on page 250
	set ap group on page 258
	set ap radio auto-tunemax-power on page 265
	set ap radio auto-tunemax-retransmissions on page 266
	set ap radio mode on page 270
	set ap radio radio-profile on page 271
	set ap auto radiotype on page 248
	set ap upgrade-firmware on page 275
External Antennas	set ap radio antennatype on page 263
	set ap radio antenna-location on page 262

Nortel WLAN—Security Switch 2300 Series Command Line Reference