Nortel Networks 2300 Series Port-list, List of physical ports, Radiotype 11a 11b 11g Radio type

52Port Commands

Note. Before configuring a port as an AP port, you must use the set system countrycode command to set the IEEE 802.11 country-specific regulations on the WSS.

See set system countrycode on page 63.

Note. For Series 2332 access points, be sure the system country code is supported for the selected access point model.

Note. For an AP that is indirectly connected to the WSS through an intermediate Layer 2 or Layer 3 network, use the set ap command to configure a AP.

Note. Before changing the port type from ap to wired-author from wired-authto ap, you must reset the port with the clear port type command.

Syntax set port type ap port-list

model {2330 2330A 2330B 2332-A1 2332-A2 2332-A3 2332-A4 2332-A5 2332-A6 2332-E1 2332-E2 2332-E3 2332-E4 2332-E5 2332-E6 2332-E7 2332-E8 2332-E9 2332-J1 }

poe {enable disable}

[radiotype {11a 11b11g}]

port-list	List of physical ports.
model {2330 2330A 2330B 2332-A1	AP model.
2332-A2 2332-A3 2332-A4
2332-A5 2332-A6 2332-E1 2332-E2
2332-E3 2332-E4 2332-E5 2332-E6
2332-E7 2332-E8 2332-E9 2332-J1 }
poe enable disable	Power over Ethernet (PoE) state.
radiotype 11a 11b 11g	Radio type:
	•	11a—802.11a
	•	11b—802.11b
	•	11g—802.11g

Note: This option applies only to single-radio models.

NN47250-100 (Version 02.51)