Nortel Networks 2300 Series manual Show roaming vlan, Output for show roaming station

VLAN Commands 95

Usage The output displays roaming stations within the previous 1 second.

Examples To display all stations roaming to the WSS, type the following command:

WSS# show roaming station		VLAN	State
User Name	Station Address
---------------------- ----------------- --------------- -----			Up
redsqa	10.10.10.5	violet

Table 12 describes the fields in the display.

	Table 2: Output for show roaming station
Field	Description
User Name	Name of the user. This is the name used for authentication. The name resides in a
	RADIUS server database or the local user database on a WSS.
Station Address	IP address of the user device.
VLAN	Name of the VLAN to which the RADIUS server or WSS local user database
	assigned the user.
State	State of the session:
	• Setup—Station is attempting to roam to this WSS. This switch
	has asked the WSS from which the station is roaming for the
	station’s session information and is waiting for a reply.
	• Up—WSS Software has established a tunnel between the
	WSSs and the station has successfully roamed to this WSS over
	the tunnel.
	• Chck—This WSS is in the process of accepting a reassociation
	request from the roaming peer WSS for a station currently
	roaming to the peer switch.
	• TChck—This WSS is in the process of accepting a
	reassociation request from the roaming peer WSS for a station
	currently roaming to this switch.
	• WInd—This WSS is waiting for network congestion to clear
	before sending the roaming indication to the roaming peer
	WSS.
	• WResp—This WSS is waiting for network congestion to clear
	before sending the roaming response to the roaming peer WSS.

See Also show roaming vlan on page 85

show roaming vlan

Shows all VLANs in the mobility domain, the WSSs servicing the VLANs, and their tunnel affinity values configured on each switch for the VLANs.

Nortel WLAN—Security Switch 2300 Series Command Line Reference