Nortel Networks 2300 Series manual Show tech-support

80System Services Commands

	Table 1: show system output (continued)
Field	Description
PSU Status	Status of the lower and upper power supply units:
	• missing—Power supply is not installed or is inoperable.
	• DC ok—Power supply is producing DC power.
	• DC output failure—Power supply is not producing DC power.
	WSS Software sends an alert to the system log every 5 minutes
	until this condition is corrected.
	• AC ok—Power supply is receiving AC power.
	• AC not present—Power supply is not receiving AC power.
Memory	Current size (in megabytes) of nonvolatile memory (NVRAM) and synchronous
	dynamic RAM (SDRAM), plus the percentage of total memory space in use, in
	the following format:
	NVRAM size /SDRAM size (percent of total)
Total Power Over	Total power that the WSS is currently supplying to its directly connected APs, in
Ethernet	watts.

See Also

•clear system on page 55

•set system contact on page 62

•set system countrycode on page 63

•set system idle-timeout on page 64

•set system ip-address on page 65

•set system location on page 65

•set system name on page 66

show tech-support

Provides an in-depth snapshot of the status of the WSS, which includes details about the boot image, the version, ports, and other configuration values. This command also displays the last 100 log messages.

Syntax show tech-support [file [subdirname/]filename]

[subdirname/]filename		Optional subdirectory name, and a string up to 32 alphanumeric
		characters. The command’s output is saved into a file with the
		specified name in nonvolatile storage.
Defaults	None.
Access	Enabled.

NN47250-100 (Version 02.51)