Nortel Networks 2300 Series manual Access Commands, Disable, Enable, See Also enable on

29

Access Commands

Use access commands to control access to the WLAN Security Switch 2300 Series (WSS Software) (CLI). This chapter presents access commands alphabetically. Use the following table to locate commands in this chapter based on their use.

Access Privileges	enable on page 19
	set enablepass on page 20
	disable on page 19
	quit on page 20

disable

Changes the CLI session from enabled mode to restricted access.

Syntax disable

Defaults None.

Access Enabled.

Examples The following command restricts access to the CLI for the current session:

WSS# disable

WSS>

See Also enable on page 19

enable

Places the CLI session in enabled mode, which provides access to all commands required for configuring and moni- toring the system.

Syntax enable

Access All.

Usage WSS Software displays a password prompt to challenge you with the enable password. To enable a session, your or another administrator must have configured the enable password to this WSS with the set enablepass command.

Examples The following command plus the enable password provides enabled access to the CLI for the current sessions:

WSS> enable

Enter password: password

WSS#

Nortel WLAN—Security Switch 2300 Series Command Line Reference