Nortel Networks 2300 Series manual Configurable Profile Parameters for APs, WSS# set ap auto

256AP Commands

Usage Table 35 lists the configurable profile parameters and their defaults. The only parameter that requires configuration is the profile mode. The profile is disabled by default. To use the profile to configure APs, you must enable the profile using the set ap auto mode enable command.

The profile uses the default radio profile by default. You can change the profile using the set ap auto radio radio-profilecommand. You can use set ap auto commands to change settings for the parameters listed in Table 35. (The commands are listed in the “See Also” section.)

Table 2: Configurable Profile Parameters for APs

Parameter	Default Value
AP Parameters
bias	high
blink	disable
(Not shown in show ap config output)
force-image-download	disable (NO)
group (load balancing group)	none
mode	disabled
persistent	none
upgrade-firmware (boot-download-	enable (YES)
enable)
Radio Parameters
radio num auto-tune max-power	default
radio num mode	enabled
radio num radio-profile	default
radiotype	11g
	(or 11b for country codes where
	802.11g is not allowed)

Examples The following command creates a profile for automatic AP configuration:

WSS# set ap auto

success: change accepted.

See Also

•set ap auto mode on page 247

•set ap auto persistent on page 247

•set ap auto radiotype on page 248

•set ap bias on page 249

•set ap blink on page 250

•set ap group on page 258

NN47250-100 (Version 02.51)