Nortel Networks 2300 Series manual Set ip snmp server, Set ip ssh, WSS# set ip snmp server enable

128IP Services Commands

•clear ip route on page 101

•show interface on page 149

•show ip route on page 153

set ip snmp server

Enables or disables the SNMP service on the WSS.

Syntax set ip snmp server {enable disable}

enable	Enables the SNMP service.
disable	Disables the SNMP service.

Defaults The SNMP service is disabled by default.

Access Enabled.

Examples The following command enables the SNMP server on a WSS:

WSS# set ip snmp server enable

success: change accepted.

See Also

•clear snmp notify target on page 104

•set port trap on page 41

•set snmp community on page 123

•set snmp notify profile on page 125

set ip ssh

Changes the TCP port number on which a WSS listens for Secure Shell (SSH) management traffic.

Caution! If you change the SSH port number from an SSH session, WSS Software immediately ends the session. To open a new management session, you must configure the SSH client to use the new TCP port number.

Syntax set ip ssh port port-num

port-numTCP port number.

Defaults The default SSH port number is 22.

Access Enabled.

NN47250-100 (Version 02.51)