Nortel Networks 2300 Series manual Set service-profile beacon, Set service-profile bridging

320AP Commands

set service-profile beacon

Disables or reenables beaconing of the SSID managed by the service profile.

An AP radio responds to an 802.11 probe any request with only the beaconed SSID(s). For a nonbeaconed SSID, radios respond only to directed 802.11 probe requests that match the nonbeaconed SSID’s SSID string.

When you disable beaconing for an SSID, the radio still sends beacon frames, but the SSID name in the frames is blank.

Syntax set service-profile name beacon {enable disable}

name	Service profile name.
enable	Enables beaconing of the SSID managed by the service profile.
disable	Disables beaconing of the SSID managed by the service profile.
Defaults Beaconing is enabled by default.
Access	Enabled.

History Introduced in WSS Software Version 3.0.

Examples The following command disables beaconing of the SSID managed by service profile sp2:

WSS# set service-profile sp2 beacon disable success: change accepted.

See Also

• set radio-profilebeacon-interval on page 285

• set service-profilessid-name on page 331

• set service-profilessid-type on page 332

• show service-profile on page 380

set service-profile bridging

Enables wireless bridging for a service profile configured for WLAN mesh services.

Syntax set service-profile mesh-service-profilebridging {enable disable}

mesh-service-profile Mesh service profile.

Enable	Enables wireless bridging for the service profile..
Disable	Disables wireless bridging for the service profile.
Defaults	None.
Access	Enabled.

History Introduced in WSS Software version 6.0.

NN47250-100 (Version 02.51)