Nortel Networks 2300 Series manual Clear ap radio, Radio-Specific Parameters, Radio all

AP Commands 249

•set ap local-switchingvlan-profile on page 260

•set vlan-profile

clear ap radio

Disables an AP radio and resets it to its factory default settings.

Syntax clear {ap port-listap ap-num}radio {1 2 all}

ap port-list	List of ports connected to the AP(s) on which to reset a radio.
ap ap-num	Number of a AP on which to reset a radio.
radio 1	Radio 1 of the AP.
radio 2	Radio 2 of the AP. (This option does not apply to single-radio models.)
radio all	All radios on the AP.

Defaults The clear ap radio command resets the radio to the default settings listed in Table 34 and in Table 37 on page 291.

Table 1: Radio-Specific Parameters

Parameter	Default Value	Description
antenna-	indoor	Location of the radio’s antenna.
location		Note: This parameter applies only to APs that
		support external antennas.
		Note: Be sure to select the appropriate antenna
		configuration that corresponds to indoor or
		outdoor operation.
antennatype	For most AP models, the default is	Nortel external antenna model
	internal.

The default for the 802.11b/g radio on model 2330A is 24883.

Note: This parameter applies only to APs that support external antennas.

Note: Be sure to select the appropriate antenna model for optimum indoor or outdoor operation.

auto-tune max- Highest setting allowed for the

powercountry of operation or highest setting supported on the hardware, whichever is lower

Maximum percentage of client retransmissions a radio can experience before RF Auto-Tuning considers changing the channel on the radio

Nortel WLAN—Security Switch 2300 Series Command Line Reference