Nortel Networks 2300 Series manual Set spantree priority, Set spantree uplinkfast

STP Commands 409

Examples The following command sets the priority of ports 3 and 4 to 48 on VLAN mauve:

WSS# set spantree portvlanpri 3-4 priority 48 vlan mauve

success: change accepted.

See Also

•clear spantree portpri on page 390

•clear spantree portvlanpri on page 391

•set spantree portpri on page 397

•show spantree on page 400

set spantree priority

Changes the STP root bridge priority of a WSS on one or all of its VLANs.

Syntax set spantree priority value {all vlan vlan-id}

priority value	Priority value. You can specify a value from 0 through 65,535. The bridge
	with the lowest priority value is elected to be the root bridge for the
	spanning tree.
all	Changes the bridge priority on all VLANs.
vlan vlan-id	VLAN name or number. WSS Software changes the bridge priority on
	only the specified VLAN.

Defaults The default root bridge priority for the switch on all VLANs is 32,768.

Access Enabled.

Examples The following command sets the bridge priority of VLAN pink to 69:

WSS# set spantree priority 69 vlan pink

success: change accepted.

See Also show spantree on page 400

set spantree uplinkfast

Enables or disables STP uplink fast convergence on a WSS. This feature enables a WSS with redundant links to the network backbone to immediately switch to the backup link to the root bridge if the primary link fails.

Syntax set spantree uplinkfast {enable disable}

enable	Enables uplink fast convergence.
disable	Disables uplink fast convergence.

Nortel WLAN—Security Switch 2300 Series Command Line Reference