Nortel Networks 2300 Series manual Set spantree portpri, Set spantree portvlancost

STP Commands 407

enable	Enables port fast convergence.
disable	Disables port fast convergence.

Defaults STP port fast convergence is disabled by default. Access Enabled.

Usage Use port fast convergence on ports that are directly connected to servers, hosts, or other MAC stations.

Examples The following command enables port fast convergence on ports 9, 11, and 13:

WSS# set spantree portfast port 9,11,13 enable

success: change accepted.

See Also show spantree portfast on page 405

set spantree portpri

Changes the STP priority of a network port or ports for selection as part of the path to the STP root bridge in the default VLAN on a WSS.

Syntax set spantree portpri port-listpriority value

port-list	List of ports. WSS Software changes the priority on the specified ports.
priority value	Priority value. You can specify a value from 0 (highest priority) through
	255 (lowest priority).

Defaults The default STP priority for all network ports is 128. Access Enabled.

Usage This command applies only to the default VLAN (VLAN 1). To change the priority of a port in another VLAN, use the set spantree portvlanpri command.

Examples The following command sets the priority of ports 3 and 4 to 48:

WSS# set spantree portpri 3-4 priority 48

success: change accepted.

See Also

•clear spantree portpri on page 390

•clear spantree portvlanpri on page 391

•set spantree portvlanpri on page 398

•show spantree on page 400

set spantree portvlancost

Changes the cost of a network port or ports on paths to the STP root bridge for a specific VLAN on a WSS.

Nortel WLAN—Security Switch 2300 Series Command Line Reference