Nortel Networks 2300 Series manual WSS# set ap 5 radio 1 tx-power

AP Commands 283

Access Enabled.

Usage You also can configure a radio’s channel on the same command line. Use the channel option.

This command is not valid if dynamic power tuning (RF Auto-Tuning) is enabled.

Examples The following command configures the transmit power on the 802.11a radio on the AP connected to port 5:

WSS# set ap 5 radio 1 tx-power 10

success: change accepted.

The following command configures the channel and transmit power on the 802.11b/g radio on the AP connected to port 11:

WSS# set ap 11 radio 1 channel 1 tx-power 10

success: change accepted.

See Also

•set ap radio channel on page 267

•show ap config on page 344

Nortel WLAN—Security Switch 2300 Series Command Line Reference