Nortel Networks 2300 Series manual Set ap radio auto-tune max-power

			AP Commands 275
antennatype	802.11a antenna models:
{internal 5303 mixed 5133 5173 5103	•	internal - Omnidirectional puck
5133-OUT 5133-OUT-10 5133-OUT-25	•	5303 - Wideband Squint
5133-NEMA 5133-NEMA-10 5133-
NEMA-25 5643 5643-OUT 5643-OUT-	•	5643	- Omnidirectional Collinear
10 5643-OUT-25 5643-NEMA 5643-
NEMA-10 5643-NEMA-25 5173-OUT		Dipole
5173-OUT-10 5173-OUT-25 5173-	•	5133	- Directional Panel, 60 degrees
NEMA 5173-NEMA-10	•	5173	- Directional Panel, 90 degrees
5173-NEMA-25 5103-OUT 5103-OUT-
10 5103-OUT-25 5103-NEMA 5103-	•	5103	- Directional Panel, 120 degrees
NEMA-10 5103-NEMA-25}	• mixed - Dual-band, Tri-mode 802.11a/

b/g Spatial Diversity Antenna

•-NEMA, -NEMA-10 & -NEMA-25 (Outdoor configurations with base antenna model)

•-OUT, -OUT-10 & -OUT-25 (Outdoor configurations with base antenna model)

Defaults All radios use the internal antenna by default, if the AP model has an internal antenna. Access Enabled.

History

Usage This command applies only to the 802.11b/g radio on model 2330.

Examples The following command configures the 802.11b/g radio on AP 1 to use antenna model 24883:

WSS# set ap 1 radio 1 antennatype 24883

success: change accepted.

See Also show ap config on page 344

Note. The options displayed are dependent upon the access point model number that this CLI command is executed against.

set ap radio auto-tune max-power

Sets the maximum power that RF Auto-Tuning can set on a radio.

Nortel WLAN—Security Switch 2300 Series Command Line Reference