Nortel Networks 2300 Series manual Set ap boot-configuration ip, WSS# set ap 3-4 blink enable

AP Commands 261

Usage Changing the LED blink mode does not alter operation of the AP. Only the behavior of the LEDs is affected.

Examples The following command enables LED blink mode on the AP connected to ports 3 and 4:

WSS# set ap 3-4 blink enable

success: change accepted.

set ap boot-configuration ip

Specifies static IP address information for a AP.

Syntax set ap ap-numboot-configuration ip ip ip-addrnetmask mask-addrgateway gateway- addr [mode {enable disable}]

Syntax set ap ap-numboot-configuration ip mode {enable disable}

ap ap-num	Number of the AP for which you are specifying static IP
	information.
ip ip-addr	The IP address to be assigned to the AP, in dotted decimal
	notation (for example, 10.10.10.10).
netmask mask-addr	The subnet mask, in dotted decimal notation (for example,
	255.255.255.0).
gateway gateway-addr	The IP address of the next-hop router, in dotted decimal
	notation.
mode {enable disable}	Enables or disables the static IP address for the AP.

Defaults By default APs use DHCP to obtain an IP address, rather than a using a manually assigned IP address.

Access Enabled.

History Introduced in WSS Software 4.1. Option dap removed in 6.0.

Usage Normally, APs use DHCP to obtain IP address information. In some installations, DHCP may not be available. In this case, you can assign static IP address information to the AP, including the AP’s IP address and netmask, and default gateway.

If the manually assigned IP information is incorrect, the AP uses DHCP to obtain its IP address.

Examples The following command configures AP 1 to use IP address 172.16.0.42 with a 24-bit netmask, and use 172.16.0.20 as its default gateway:

WSS# set ap 1 boot-configuration ip 172.16.0.42 netmask 255.255.255.0 gateway 172.16.0.20

success: change accepted.

See Also

•clear ap boot-configuration on page 241

•set ap boot-configuration switch on page 255

•set ap boot-configuration vlan on page 256

Nortel WLAN—Security Switch 2300 Series Command Line Reference