Nortel Networks 2300 Series Set system countrycode, 23x0#set system contact tamara@example.com

System Services Commands 73

Examples The following command sets the system contact information to tamara@example.com:

23x0#set system contact tamara@example.com

success: change accepted.

See Also

•clear system on page 55

•set system location on page 65

•set system name on page 66

•show system on page 68

set system countrycode

Defines the country-specific IEEE 802.11 regulations to enforce on the WSS.

Syntax set system countrycode code

code	For the two-letter country code, refer to the approved list of country
	codes "Approved Countries for the WLAN 2300 Series Components"
	located at http://www.nortel.com/support.

Note. For a complete listing of the models in the WLAN Series 2332 and their respective countries of operation, please visit http://www.nortel.com/support.

The Series 2332 access point has been region-locked to meet geographic regulatory restrictions. Each model is associated to a specific regulatory domain and subsequent country of operation. During installation, the access point model and wireless security switch regulatory domain must match or the access point will not operate.

Defaults The factory default country code is None. Access Enabled.

Usage You must set the system county code to a valid value before using any set ap commands to configure an Access Point (AP).

Examples To set the country code to Canada, type the following command:

23x0#set system country code CA

success: change accepted.

Nortel WLAN—Security Switch 2300 Series Command Line Reference