Nortel Networks 2300 Series manual Output for show spantree

412STP Commands

Port Vlan STP-State Cost Prio Portfast

------------------------------------------------------------------------------

1	1	Forwarding	19	128	Disabled
2	1	STP Off	19	128	Disabled
3	1	Disabled	19	128	Disabled
4	1	Disabled	19	128	Disabled
5	1	Disabled	19	128	Disabled
6	1	Disabled	19	128	Disabled
7	1	Disabled	19	128	Disabled
8	1	Disabled	19	128	Disabled

Table 59 describes the fields in this display.

Table 2: Output for show spantree
Field	Description
VLAN	VLAN number.
Spanning Tree Mode	In the current software version, the mode is always PVST+,
	which means Per VLAN Spanning Tree+.
Spanning Tree Type	In the current software version, the type is always IEEE, which
	means STP is based on the IEEE 802 standards.
Spanning Tree Enabled	State of STP on the VLAN.
Designated Root	MAC address of the spanning tree’s root bridge.
Designated Root Priority	Bridge priority of the root bridge.
Designated Root Path Cost	Cumulative cost from this bridge to the root bridge. If this WSS
	is the root bridge, then the root cost is 0.
Designated Root Port	Port through which this WSS reaches the root bridge.
	If this WSS is the root bridge, this field says We are the root.
Root Max Age	Maximum acceptable age for hello packets on the root bridge.
Root Hello Time	Hello interval on the root bridge.
Root Forward Delay	Forwarding delay value on the root bridge.
Bridge ID MAC ADDR	This WSS’s MAC address.
Bridge ID Priority	This WSS’s bridge priority.
Bridge Max Age	This WSS’s maximum acceptable age for hello packets.
Bridge Hello Time	This WSS’s hello interval.
Bridge Forward Delay	This WSS’s forwarding delay value.
Port	Port number.
	Note: Only network ports are listed. STP does not apply to AP
	ports or wired authentication ports.
Vlan	VLAN ID.

NN47250-100 (Version 02.51)