Nortel Networks 2300 Series manual Set boot configuration-file, Set boot partition

560File Management Commands

Examples The following command specifies a file called backup.cfg as the backup configuration file on the WSS:

WSS# set boot backup-configuration backup.cfg

success: backup boot config filename set.

See Also

•clear boot backup-configuration on page 537

•show boot on page 551

set boot configuration-file

Changes the configuration file to load after rebooting.

Syntax set boot configuration-file filename

filename	Filename. Specify between 1 and 128 alphanumeric characters, with no
	spaces.
	To load the file from a subdirectory, specify the subdirectory name,
	followed by a forward slash, in front of the filename. For example:
	backup_configs/config_c.

Defaults The default configuration filename is configuration. Access Enabled.

Usage The file must be located in the switch’s nonvolatile storage.

Examples The following command sets the boot configuration file to testconfig1:

WSS# set boot configuration-file testconfig1

success: boot config set.

set boot partition

Specifies the boot partition in which to look for the system image file following the next system reset, software reload, or power cycle.

Syntax set boot partition {boot0 boot1}

boot0	Boot partition 0.
boot1	Boot partition 1.

Defaults By default, a WSS uses the same boot partition for the next software reload that was used to boot the currently running image.

Access Enabled.

NN47250-100 (Version 02.51)