1 5
C o n f i g u r i n g t h e d i g i t a l s u r r o u n d c o n t r o l l e r
Configuring the digital surround controller
This chapter explains how to configure the digital surround controller using the Configuration Wizard. Alternatively, for complete control over all aspects of the product’s configuration you can set up the unit from a computer using the Meridian Configuration Program. For full information refer to the Meridian Configuration Program Guide available separately.
Configuration Wizard
The Configuration Wizard leads you through the correct sequence to configure your digital surround controller. Alternatively, you can skip between the configuration stages, which allow you to reset the configuration, or configure the sources or other settings of the digital surround controller.
To run the Configuration Wizard
•If necessary press On/Off to put the digital surround controller into standby.
•Press More.
If the product is locked the display shows:
VersionUnlock
• Press Unlock to unlock it, then press More.
The displays then shows:
Version | Wizard Calib Lock |
• Press Wizard.
Follow the sequence of configuration stages described in the following pages, pressing Next to proceed after each stage.
At any stage in the Configuration Wizard the following options are available:
To do this | Press |
Go back to an earlier configuration option | Back |
Return to the title screen for the stage | Home |
Exit from the configuration menus | On/Off |
Display help about the current option | More |
