HP 175X slp-config ttl-slp idle-timeout telnet-timeout ews-config tcp-mss, tcp-msl telnet-config

slp-config:

ttl-slp:

idle-timeout:

telnet-timeout:

ews-config:

tcp-mss:

tcp-msl:

telnet-config:

Enables or disables the Service Location Protocol (SLP) operation on the print server. SLP is used by selected HP software applications to automate device discovery.

0Disables.

1(default) Enables.

Specifies the IP multicast Time To Live (TTL) setting for Service Location Protocol (SLP) packets. The default value is 4 hops (the number of routers from the local network). The range is 1–15. When set to -1, multicast capability is disabled.

The number of seconds that an idle print data connection is allowed to remain open. Since the card supports only a single TCP connection, the idle timeout balances the opportunity of a host to recover or complete a print job against the ability of other hosts to access the printer. The acceptable values range from 0 to 3600 (1 hour). If set to 0, the timeout mechanism is disabled. The default is 270 seconds.

An integer (1..3600) that specifies the number of seconds that your Telnet or FTP session can be idle before it will be automatically disconnected. The default is 900 seconds. 0 disables the timeout. CAUTION: small values, such as 1–5, may effectively disable the use of Telnet. A Telnet session may terminate before any changes can be made.

Enables or disables the embedded web server to view or change configuration values:

0Disables.

1(default) Enables.

Specifies the maximum segment size (MSS) that the print server will advertise for use when communicating with local subnets (Ethernet MSS=1460 bytes or more) or remote subnets (MSS=536 bytes):

0(default) All networks are assumed to be local (Ethernet MSS=1460 bytes or more).

1Use MSS=1460 bytes (or more) for subnets, and MSS=536 bytes for remote networks.

2All networks are assumed to be remote (MSS=536 bytes), except the local subnet. MSS affects performance by helping to prevent IP fragmentation that may result in data retransmission.

Specifies the maximum segment life (MSL) in seconds. The range is 5–120 seconds. The default is 15 seconds.

Enables or disables incoming Telnet connections:

0Disallows them. (To regain access, change the setting in the TFTP configuration file and power cycle the print server, or cold-reset the print server to factory default settings.)

1Allows them.

SNMP parameters for TFTP

TFTP Parameter

snmp-config:

get-community-name:

set-community-name:

auth-trap:

Description

Enables or disables SNMP operation on the print server:

0Disables.

1(default) Enables.

Specifies a password for SNMP GetRequests sent to the print server. This password is optional. If a user-specified get community name is set, the print server will respond to either a user-specified community name or the factory-default. The community name must be ASCII characters. The maximum length is 255 characters.

Specifies a password that determines which SNMP SetRequests (control functions) the print server will respond to. The community name of an incoming SNMP SetRequest must match the print server’s set community name for the print server to respond. SetRequests must come from hosts that are configured in the print server’s host access list. Community names must be ASCII characters. The maximum length is 255 characters.

Configures the print server to send (on) or not send (off) SNMP authentication traps. The default is on. Authentication traps indicate that an SNMP request was received, but the community name check failed.