HP 175X, 310X manual Telnet Parameter, Description and Values

Telnet Parameter

snmp-config

get-community-name

set-community-name

auth-trap

Description and Values

Enables or disables SNMP operation on the print server:

0Disables.

1(default) Enables.

Specifies a password for SNMP GetRequests sent to the print server. This password is optional. If a user-specified get community name is set, the print server will respond to either a user-specified community name or the factory-default. The community name must be ASCII characters. The maximum length is 255 characters.

Specifies a password that determines which SNMP SetRequests (control functions) the print server will respond to. The community name of an incoming SNMP SetRequest must match the print server’s set community name for the print server to respond. SetRequests must come from hosts that are configured in the print server’s host access list. Community names must be ASCII characters. The maximum length is 255 characters.

Configures the print server to send (on) or not send (off) SNMP authentication traps. The default is on. Authentication traps indicate that an SNMP request was received, but the community name check failed.

trap-dest	Enters a host’s IP address into the print server’s SNMP trap destination list. The command
	format is:
	trap-dest ip-address [community name] [port number]
	ip-addressis the host IP adress.
	community name is optional (the default community name will be used),
	except in two cases:
	● when specifying the port number. If you do not specify a community
	name, the port number will become the community name.
	● when a trap-community-name entry precedes any trap-dest
	entry. If you do not specify a community name here, that trap
	community name will be assigned to this entry.
	port number is optional (the default SNMP port number 162 will be
	used).
	Setting trap-dest 0 deletes the trap destination list. If the list is empty, the print
	server does not send SNMP traps. The list may contain up to five entries. The default
	SNMP trap destination list is empty. To receive SNMP traps, the systems listed on the